1.0.0
Latest #The first release: two compressors — the VCA, the classic console bus compressor modeled as its circuit, and Airwindows Logical4, ported statement for statement (bit-exact against the reference at 44.1, 48 and 96 kHz) — with the Techne facilities around them: a detector high-pass, a trim, MATCH, a 10 ms bypass crossfade, the gain-reduction history on the screen, presets, A/B — in the family's design.
Full notesHide full notes
- ENGINE: VCA | LOGICAL4, the VCA for a new instance. The VCA is the console bus compressor's side chain as a circuit, not a sound-alike: one timing capacitor charged through the ATTACK resistor and drained through the RELEASE one, a detector that reads the compressed signal, both channels on one node so one gain moves the pair. THRESHOLD is in dBFS (−40 … 0, the dial of the software model below, 1 dB for 1 dB: a steady tone starts to be compressed at 4:1 just over it), RATIO 2:1 / 4:1 / 10:1, ATTACK 0.01 … 30 ms, RELEASE 0.1 … 1.2 s and AUTO. Its constants are fitted, sample by sample, to the gain a long-standing software model of that compressor applies on an analog unit's own calibration signals, and checked against it at all 27 settings fitted (the 0.01 ms attack and the 0.4 and 0.8 s releases, steps the analog unit does not have, among them): 0.02 dB apart on average; releases (AUTO's two speeds included) within 1 %; the 4:1 attacks within 9 % to 63 % (18 % to 90 % at 0.3 ms), 2:1's 9–54 % fast, 10:1's at 30 ms 23 % fast and at 0.1 ms 25 % slow, its last tenth landing a carrier peak late (2.5×); steady depths within 0.1 dB except 2:1 at 30 ms (0.4 dB light); the static curves within 0.02 dB. The same law fitted to the analog unit's measured traces stays in the code as the reference it is checked against. No latency, no oversampling. MAKEUP, MIX, SC HPF, OUTPUT and COLOR are shared; Logical4 keeps its own THRESHOLD, RATIO, SPEED and the attack / release split. A switch crossfades over 10 ms into the other engine, which has been running underneath, so it comes in at its own level. The host lists Logical4's parameters as L4 Threshold, L4 Ratio, L4 Speed, L4 Attack/Release and L4 Release (their ids are unchanged). A session, a preset or a SET AS DEFAULT file saved by an earlier build opens on LOGICAL4, as it sounded; four VCA presets join the factory set, with Glue Drums and Gel Master.
- COLOR: the Tube's harmonics circuit as a third section. EVEN and ODD set the amount of each order; PRE puts it before the compressor (which then reacts to the harmonics), off it sits after MIX. The level is kept, so the dials change the harmonics, not the loudness. On by default, gently (EVEN 12 %, ODD 13 %); the LOGICAL4 preset is the exact skip. The curve is anti-aliased in closed form and follows the level, so quiet material and tails come out cleaner. A 2× key oversamples it through the family's half-band (90 dB) for hot, bright material at high amounts, at 35 samples of latency the host compensates; off, the default, there is no latency. (rc2's key told the host 0 at every activation and 35 a block later; Live restarts a plugin whose latency changes, so with the key on it restarted every few blocks — crunching and dropouts. The latency is now the key's from the activation on.) Under 2× everything is as late as the host is told: with EVEN and ODD at 0 rc2 passed the audio through undelayed, and BYPASS faded to the undelayed input — both 35 samples ahead of the compensation; now both wait.
- PORTRAIT, after a look at it in a host: ANALYSIS is the meter's (a display bar under the glass, at the right), not a key beside ENGINE; THRESHOLD shows its position as the other dials do, a blue arc, with the input's nodes around it amber past the pointer; RATIO's detents are numbered (2 · 4 · 10, WIDE too); the meter's marks stand evenly spaced (0 1 2 3 4 6 8 10 15 20); SETTINGS → METER gives the dial the backlit face too; the 2× key dips the output for about 12 ms around its switch instead of tearing (and a host that restarts the plugin for the new latency gets it back from silence).
- COLOR has its own switch: the lamp key in its title row (WIDE), ON beside its heading (PORTRAIT). Off passes the compressor's signal untouched and keeps EVEN, ODD, PRE and 2× as they were, with a 10 ms crossfade; on by default, and every session and preset from before the switch opens on.
- EXT SC: the VCA can be keyed from the host's sidechain input — a kick to pump a bus, a vocal to duck one. The key takes the program's place in the compressor's side chain, through SC HPF, at the same THRESHOLD, RATIO, ATTACK and RELEASE; THRESHOLD's ring shows the key's level, and with nothing routed the meter says NO KEY. Its key sits beside ENGINE, where A/R is under LOGICAL4 (Logical4 has no key input). Stereo and mono, in VST3, CLAP and AU (Logic's mono tracks included). A switch crossfades the two keys over 10 ms. Not saved in presets, A / B or SET AS DEFAULT: it's routing, like the host's own sidechain menu.
- CLIP: a clipper at the end of the chain, after OUTPUT — the compressor glues a bus and leaves its peaks, and can lift them; CLIP stops them at CEILING (−24 … 0 dBFS, a sample ceiling, not true peak). The Clipper's curve with a soft knee at the host rate: no oversampling and no latency. On four bus-compressed drum loops peaking 3 dB over a −6 ceiling it held the peaks at −6.0 for 0.02 to 0.04 LU. PORTRAIT: CLIP's key under PRE | POST, its red lamp brighter as it bites, CEILING on a small dial with its value (click to type); WIDE: the key and the value at the end of LEVEL's row. Off for a new instance and in every earlier session and preset; presets, A / B and SET AS DEFAULT carry it.
- The editor is PORTRAIT: a tall editor (460 × 764 at 100 %), built around the gain reduction — a needle meter the width of the faceplate on a scale that gives the first few dB room (0 1 2 3 4 6 8 10 15 20), the needle's reading as a large number on it, THRESHOLD the largest dial with RATIO, SC HPF, ATTACK and RELEASE beside it, LEVEL and COLOR on the same columns under them. ANALYSIS, under the meter, opens the screen (history, meters, loudness) under the controls and the window grows downward (on a Mac, a little smaller where the screen is short). An engaged key (MATCH, BYPASS, EXT SC, A/R, COLOR's ON and 2×) lights its lamp and sits a little lower, its face the panel's; BYPASS's lamp is red. Kept per machine; the parameters, presets and sessions are the same in both.
- PORTRAIT's dials: a flat cap on a dark collar, the value a thin ring around it, ticks at each control's marks (a stepped control's at its positions) and its range's ends printed beside it; THRESHOLD prints its whole scale, every 10 dB. THRESHOLD's ticks are its input meter: lit as far as the input reaches, blue under the threshold, amber past it, the top one red over 0 dBFS; unlit, they are its scale.
- SETTINGS → PLATE: DARK or CONSOLE GRAY — PORTRAIT on the family's graphite or on a console's light gray, its print dark, its keys and its meter window black. Kept per machine.
- The activation card in the family's style: the state as a lamp (DEMO, LICENSED), the email and the key in labeled fields, CLOSE and ACTIVATE.
- SETTINGS → TOOLTIPS: ON (the line at the foot names the control under the pointer, its value, range and what it does) or OFF (only how the editor is worked). Kept per machine.
- RATIO ends at 9. Logical4 runs to 16, but its third stage's control rests at SPEED × its target, so past 9 at any SPEED short of the slowest the cells expand instead of compressing (a burst at −3 dBFS came out at +6.8, with the meter reading 0). Two stages are the product.
- SC HPF is 80 Hz for a new instance. With it off, a 30 Hz sub at −6 dBFS put 6.5 dB of ripple on the gain within its own cycle; at 80 Hz it is 0.6. OFF is still Logical4 exactly, and the LOGICAL4 preset keeps it.
- Fixed: after a burst into digital silence (a stopped transport, rendered silence between regions) the gain reduction held for ever — 5 dB on the readout beside NO SIGNAL — and the first transient after the gap met a stale cell on its negative half. Logical4's denormal guard feeds the cells a noise that is always positive, so only the positive side's controls ever let go. The guard now carries a sign; on any sample that is not exact silence the arithmetic is unchanged.
- BYPASS is the host's bypass too (Live's device switch, a VST3 insert's bypass), so it takes the crossfade and the compressor keeps running underneath.
- MATCH's gain and the loudness meters survive the host's reset (REAPER and the VST3 wrappers reset on every play), so an A/B with MATCH on no longer starts at unity and relevels over three seconds at each play press. RESET on the readouts still clears them.
- OUTPUT is ±24 dB (was ±12): MATCH's gain reaches ±24, and baking it into OUTPUT clamped silently.
- A session saved bypassed opens bypassed from its first sample (the crossfade used to start from the processed side).